Original factory DIY  6.5 Inch scooter Motherboard Controller For Balance Smart Scooter Hoverboard 

We are the Brazilian brand "FOSTON" Original factory!!

!!! Only For 6.5 Inch Scooter USE as Below Pattern:

Features:

1. New High Stable Quality Smart Scooter Parts Motherboard Control Board for Universal All Models 9 Items in Total
2. Original taotao mainboard with 32-bit microcontroller as the master chip
3. Use Rail to Rail technology,will never power off,will never happen can not charge.
4. It has left and right balance, drive straight,do not turn
5. High-speed running smoothly
6. MOS tube,ST chip all from original imported
7. Capacitors using big brand emerald,and life is 2.5 times than other common capacitors
8. Cable are UL certified,all boards have the CE, ROHS, FCC certification
9. High quality and stable
10. All boards hase been tested,work well

Package include:

• 1 Mainboard
• 2 Gyroscope boards, ,
• 2 Front LED lights boards
• 2 Power Indicator boards,
• 1 Charger line
• 1 Power switch cord
• 1 Bluetooth module
• 1 Speaker 3w

Note:

The bluetooth module and speaker is not included the scooter motherboard,you need to choice color "2".

Description:

The mainboard has 3 sockets:

Left side 2 pin port is for switch line;Right 4 pin port is for charging line;middle 3 pin is for bluetooth module.
-The gyro have 4 sockets:
Left side 2 pins socket is for L or R Light;Right 4 pins socket is for (4 LED mainboard  indicator or 6LED Power indicator),and middle 3 pins socket is for revolving lights.

Controller calibration study : turn off scooter first, long press the power button for 5 seconds, "drip" sound until around headlights flash, attitude data successfully saved, to be re-switch. (In the calibration, be sure to keep the left and right pedals parallel to the ground.)

Note:Every new board should make calibration after you install.

Mode switch: Power Default low sensitivity mode (beginner mode).Be off state, press the power button, and within seconds the power button is pressed again, the sound issue drop, mode switch to high-sensitivity mode (motion mode). Reboot back to learning mode.

Tilt protection: stepping on the pedal, the pedal must be less than the level of 80 degrees ,If beyond the angle, the motor stops, status indication red. Power indicator board each 6 LED. Cool side panel of each lamp 8 LED.
Uses: Suitable for assembling electric scooter car.

The microcontroller has been programmed.Just assemble them to use.