433 MHz rf wireless Remote Control DC 12V 10A 1CH Relay Receiver and transmitter for garage/Electric Door/Signal transmission  

Relay Receiver Board Parameter

• Working voltage  :  DC 12V

• Input vlotage  :  1~250V

• Output vlotage  :  1~250V

• Quiescent Current  :  <5MA

• Max current  :  10A

• Max load:   2200W

• RF frequency  :  433MHz

• Pin  :  NO / COM / NC

• Working temperature  :  -30~+80 Celsius

• Receiving Sensitivity  :  >97dbm

• Amount of storage remote controls  :  25 pieces

• Support encoding  :  1527 Leaning code /2262 fixed code

• RF Operating mode  :  ASK superheterodyne wireless reception

• Receiving range  :  Open space is more than 50 meters

• Remote operating mode   : Momentary Mode / Toggle Mode / Latched Mode  / Delay Mode

Products can be used in homes, farms, factories, offices, laboratories, supermarkets and so on.
Remote control garage door \  Electric door \ house door \ shutter door \ expansion door \ gate door \ road gate
Remote control Electric curtain \ Water pump \ Fan \ Lamp \ LED light \ bulb \ ventilation device \ Signal transmission

Working Modes
You can set up in 3 modes: Momentary mode,Toggle mode and Latched mode.
Momentary mode:
Press and hold A button,this relay will work;Release A button,this relay will stop.
Toggle mode:
Press A button,the relay will work;press A button again,this relay will stop.
Latched mode:
Press A button,the relay will work;press B button again,this relay will stop,second relay will work.
How to Set up
Momentary mode:
Press learning button once,press A button once,succeed.
Toggle mode:
Press learning button twice,press A button once,succeed.
Latched mode:
Press learning button 3times,press A button once,succeed.
Clean data:
Press learning button 8times,the data will be cleaned.All remotes cannot control this receiver.
If u want to change modes,u need to clean the data first.